V9-R Heat Pump Controller

Control characteristics

Control mode

Asynchronous motor Sensor-less control/Synchronous motor Sensor-less control

Starting torque

Asynchronous motor:
200% of rated torque at 0.25Hz           
Synchronous motor:
150% of rated torque at 1.5% of rated speed

Speed regulation range

1:200

Steady speed precision

± 0.5%

Maximum Frequency

2000Hz

Torque control

Yes

Torque control precision

±5%

Torque response time

<20ms

Product function

Key function

Torque limit, speed control, positioning control, motor auto tune, deep flux-weakening control, current limit control, over-voltage control, under-voltage control, motor speed tracing function, droop control, oscillation suppression, random carrier frequency, inertia auto-tune, etc.

Speed reference source

Modbus communication, Keypad,

Modbus communication

Built in Modbus RTU communication (RS − 485), the standard operation panel can realize the function of remote control box

Protection function

Power supply under-voltage, over-current protection, over-voltage protection,abnormal baseline,auto-tune fault, module protection, heat-sink overtemperature protection, drive overload protection, motor overload protection, peripheral protection, current abnormal detection, output short-circuit to ground protection,abnormal power loss, abnormal input power supply, EEPROM abnormal detection, abnormal closing of buffer relay,temperature sampling disconnection, encoder disconnection, analog input abnormal detection, motor overtemperature,communication fault, hardware overload protection, etc.

Efficiency

≥93%

Environment

Operating site

●  Install vertically in a well-ventilated electrical cabinet. Horizontal or other installation methods are not allowed.
● The cooling medium is air.
● Installed in an environment free from direct sunlight, dust, corrosive gases, flammable gases, no oil mist, no steam, no dripping.

Ambient temperature

● −10～+40℃
● Derating use when the temperature between 40 to 50℃, the rated output current is reduced by 1% for every 1 °C increasing.

Humidity

5～95%, no condensation is allowed.

Altitude

● 0～2000 meters
● Derating use when the altitude over 1000 meters, the rated output current is reduced by 1% for every 100-meter rising.

Vibration

3.5 m/s2 ，2~9Hz；10 m/s2 ，9~200Hz；15 m/s2 ，200~500Hz

Storage temperature

−40~+70C

Terminal Type

Symbol

Function description

Technical specifications

24V

+24V

+24V

24V±10%, internal isolated with GND；Maximum load 200mA, overload and short circuit protection

PLC

X terminal power common terminal

Short to +24V by default

Digital inputs

X1

Multi function input terminal 1

Input: 24VDC , 5mA

Frequency： 0~1KHz Voltage： 24V±20%

COM

X terminal power common terminal

Internal isolation from GND

GND

GND

Analog GND

10V power supply grounding or shielding grounding of 485 communication

10V power supply

10V

10V  power supply

Analog inputs

AI1

Analog input 1

Select 0 / 4mA ~ 20mA or 0 ~ 10V through jumper

RS485

485−

RS485 negative end

485+

RS485 positive end

Relay outputs

RA

Relay outputs

RA－RB：Normally closed

RB

RA－RC： Normally open

RC

Contact capacity： 250VAC/1A
30VDC/1A