【Dry Goods]The whole process of high frequency transformer manufacture

by:V&T Technologies     2020-02-22
The circuit diagram of high frequency transformer is shown in Fig. 1. Fig. 1 circuit diagram of high frequency transformer and manufacturing process of high frequency transformer are shown in Fig. 2. Fig. 2 the manufacturing process of high-frequency transformer. The manufacturing of high-frequency transformer roughly includes the following ten processes. The process, process and matters needing attention of each process are analyzed in detail. 1. Winding (1)Material confirmation 1)Transformer skeleton (BOBBIN)Confirmation of specifications. 2) When cutting unused pins, they should be cut off before winding, in case they will scratch the lines or cut the wrong feet after winding, and it can avoid winding the wrong feet when winding. 3)Confirm that the skeleton is complete and there must be no damage or cracks. 4) Insert the skeleton into the fixture correctly, and the general special mark is pin 1 (PIN1) , If the drawing is not indicated, pin 1 faces the machine. 5) If the acetate cloth must be wrapped, wrap it according to the requirements of the engineering drawing, close to both sides of the skeleton, and then wrap the wire on the specified pin (Or hook line first) After the start of the winding, in principle, the winding should be wound within the specified range. 12345678 Next Page>
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...