Domestic servo motor brand-Factory quality pass

by:V&T Technologies     2020-01-29
Domestic servo motor manufacturers pass the quality standard. It should be noted that Servo Motors should be inspected during operation so as not to cause unnecessary losses and affect normal work. Domestic servo motor manufacturers have high quality, so attention should be paid to the wear of accessories during use, and the power supply should be disconnected in time if there is a stop. Before use, all parts of the motor should be checked, and only when there is no problem can it be used. For the monitoring of each instrument of the motor, the standard of numerical value should be solved in time. In addition, during installation, it is strictly prohibited to hit with a hammer to prevent excessive axial force or radial force from damaging bearings or gears. Be sure to tighten the mounting bolt before tightening the force Bolt. Before installation, wipe the antirust oil of the motor input shaft positioning boss and Reducer connection with gasoline or zinc sodium water. Its purpose is the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear. Power off the control card and connect the signal line between the control card and the servo. The following lines are the encoder signal lines that must be connected to the analog output line of the control card to enable the signal line servo output. After reviewing the wiring without errors, the motor and control card (And P power on. At this time, the motor should not move and can be easily rotated by external force. If not, check the setting and wiring of the enable signal. Rotate the motor with external force and check whether the control card can correctly detect the change of the motor position, otherwise check the wiring and setting of Encoder Signals. The operation of stepping motor requires some external electrical components. These external components usually include power logic programmer switching elements and clock pulse sources. Many commercial drives have combined these pieces into a whole. These basic drivers have only the last power stage and no electronic controller that can generate the appropriate step sequence. The servo is mainly positioned by pulses. Basically, it can be understood that when the servo motor receives a pulse, it will rotate the angle corresponding to a pulse, thus realizing displacement, because, the servo motor itself has the function of sending out pulses, so every rotation angle of the servo motor will send out a corresponding number of pulses, thus forming a Echo with the pulses received by the servo motor, or a closed loop, in this way, the system will know how many pulses are sent to the servo motor and how many pulses are received at the same time, so that the rotation of the motor can be controlled very well, the positioning thus realized can be achieved. TAG domestic servo motor
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...